Greetings from an idyllic cove in the Ionian, where we are anchoring in crystal clear water! We did eventually get back in the water, but this post is still about our boat’s bottom renovation, its third and last part. Replacing our thru hulls was the actual reason for our boatyard visit, but then we discovered more pressing matters with the hull. I wrote about them in the previous posts, parts 1 and 2.
Last time I wrote about our boat plumbing project. Our freshwater system was now ready and working, and the next phase was to rebuild the saloon that had been pulled apart. The old cushions were also ready for the dumpster (one was good enough for Anouk the marina dog’s bed in the cockpit) – we would buy new ones and upholster them ourselves. The settees would be rebuilt with only minor changes to the measurements. The starboard settee would slide out to make a wider sea berth, and the port settee would be a little deeper than before. The new water tanks had found their place under the settees, and we could add some storage on both sides as well.
We’re back from the beautiful shores of the Atlantic Ocean. It’s officially spring – never mind the snow that stubbornly keeps falling and the freezing northerly wind that blows your hat off and makes your limbs stiff. It’s spring, and like I said in my last post, time to get our hands dirty. And dirty they are!